09/12/2024 13:33:54

Dolly Platform Pre-Use Inspection

Warning IconA warning icon, calling your attention to a possibly risky situation
Warning
Perform the following steps before using the dolly platform to avoid serious damage or injury.
  1. Confirm all platform components are present:
    • A: Dolly platform
    • B: (4) Removable legs
    • C: (1) Removable tray
  2. Squeeze the latch to remove the tray on the end of the platform.
  3. Inspect the tray:
    1. Confirm the (2) plastic slide pieces are present and are not damaged.
    2. Confirm the recessed metal strike plate is installed on the right side slide piece.
    3. Confirm the latch on the removable tray slides smoothly and springs back into place when released.
    4. Replace the tray and confirm it latches into place.
  4. Inspect each of the (4) legs for the following:
    • Swiveling foot is present, and is not loose or damaged
    • Attached clevis pin is present and tethers are intact
    • Clevis pin is not bent and can be locked correctly
  5. Inspect the main platform for the following:
    • Loose fasteners
    • Missing components or fasteners
    • Grip tape is secure and not coming loose
    Warning IconA warning icon, calling your attention to a possibly risky situation
    Warning
    If any parts are missing, damaged, or otherwise unfit for use, repair or replace the platform before using it.
  6. Remove the pins holding the platform legs in the storage configuration, then slide the legs out from the tabs holding them in place.
  7. Insert each leg into its slot on the platform, then secure the leg in place with the pin.
    Informational PurposesAn informational icon, calling your attention
    Note
    If using the platform on level ground, ensure each leg uses the same hole. If using the platform on a non-level surface, adjust the pin location to level the platform.
  8. Position the platform against the wall and center it on the bracket. Confirm the feet sit flat on the ground and are not sitting on any loose rocks or debris.