Tesla Remote Meter is "Unable to Read Data"

On the Tesla Remote Meter page, an "Unable to Read Data" error is displayed.

Figure 1. Wi-Fi Connected Tesla Remote Meter Displaying Error
  1. The meter may be performing a firmware update. Wait 5 minutes before proceeding.
  2. On the landing page, Stop System then Start System again
  3. Power cycle the Tesla Remote Meter:
    1. Turn the Tesla Remote Meter breaker OFF.
    2. Wait approximately 5 seconds.
    3. Turn the Tesla Remote Meter breaker ON.
    4. Confirm the meter LED is blinking green.