The Metering card is used to pair a
remote energy meter with the Solar Inverter to perform site and/or solar monitoring.
Note
Ensure the Solar Inverter is on software version 22.9 or later (see Software Card for instructions to
update the system software).
Scan QR Code to Pair a Wireless
Meter
Beginning with software version 22.9, a Neurio meter with a QR code printed on the
label can be paired by simply scanning that QR code. A QR code can be identified by
squares in three of the four corners of the code:
If the label has a datamatrix instead of a QR code, see Pair Meter Manually.
To pair a new meter:
Select the arrow for Metering.
Power cycle the Neurio W2 meter
and wait to hear the startup chime. Ensure the meter LED is solid green,
indicating the meter is ready to pair.
Note
If the meter is wired to a
breaker, turn the breaker off then on to power cycle the meter.
Alternatively, unplug the AC power harness from the meter, then plug it back
in to power cycle.
Select the Scan Barcode button.
Using the configuration device,
take a photo of the barcode on the Neurio meter:
Cover the Neurio LED to
reduce glare.
Position the device's
camera approximately 10 inches from the label with the QR code centered
in the frame.
Take a photo.
Select Use Photo.
Configure the CTs to match the
locations where they were installed.
On the landing page, review the
Site Meter and Tesla Solar Inverter
Meter values and ensure they match the expected values.Figure 1. Configure CTs (left)
and Review Metering Values (right)
Pair Meter
Manually
To pair the meter by manually
entering its short ID and password:
Select the arrow for Metering.
Select Enter
Manually.
Enter the meter Short ID
and Serial Number but do NOT select Connect yet.
Power cycle the Neurio
meter and wait to hear the startup chime.
Note
If the meter is wired
to a breaker, turn the breaker off then on to power cycle the meter.
Alternatively, unplug the AC power harness from the meter, then plug
it back in to power cycle.
Ensure the Neurio meter
LED is solid green, indicating the meter is ready to pair.
Within 60 seconds of
hearing the startup chime, select Connect in the
Configuration Interface.
Note
When pairing
is in progress, the meter LED will blink purple. If the pairing was
successful, the meter LED will light solid purple and a Neurio meter
connected message will appear in the Configuration Interface indicating successful connection.
NoteWhen pairing is in progress, the meter LED will blink purple. If the pairing was successful, the meter LED will light solid purple and a Neurio meter connected message will appear in the Configuration Interface indicating successful connection.