A Neurio meter must be paired with the Site Controller if:
The system has an Expansion Powerwall+ (the factory-installed
Neurio meter must be paired with the Site Controller)
The system requires remote Site,
Solar, Load, Generator, or Conductor metering that can't be performed by the
Gateway's wired built-in Meter X or Y, or by any existing Neurio meter(s)
Select Add Wi-Fi Meter at the bottom
of the Metering page.
Using the commissioning phone, take a
photo of the QR code on the Neurio meter:
Select Scan QR Code.
Position the device's camera
approximately 10 inches from the label with the QR code centered in the
frame.
A green icon with a check
mark will appear to indicate the QR code has been scanned.
Wait for the Neurio Setup to
complete, then select Done.
Note
If the meter cannot be
paired by scanning the QR code, select Manually Enter Details.
Enter the Short ID and Serial Number from the meter label; if the Neurio meter
LED is not already solid green, turn the meter breaker off then on to power
cycle the meter, and wait to hear the startup chime. The system will begin pairing automatically once the Neurio has powered
on. Wait for pairing to complete and select Done.
Configure the Remote Energy Meter
CTs:
Note
The Remote Energy Meter
has four CT ports, with the following voltage references:
CT1: L1
CT2: L2
CT3: L2
CT4: L1
Solar: Used to
measure Solar.
Solar RGM: Used to
measure Solar when revenue-grade metering (RGM) is required. Select this
option when measuring Solar for SREC.
Note
If using a single CT to
measure Solar or Solar RGM, toggle on 1CTx2 in the CT Modifiers.
This will prompt the software to double the output from the CT to
calculate total Solar output.
Site: Used when two
CTs are installed (on both L1 and L2 conductors) to measure Site.
Note
If any of the CT readings
are inverted and it has been confirmed that they are oriented correctly, select
the Flip check box to
correct the reading.
Review the vitals for each CT
(voltage, current, and power factor) to confirm they have been installed and
configured correctly.
Note
The live
power flow and current readings are available for each CT in real time, as well
as an overview of all meters and CT settings, in the Metering tab.