19/06/2023 09:52:51

Step 1: Prepare for Installation

  1. Turn off the Powerwall+ battery assembly by setting its Enable switch to the OFF position.
  2. Turn off the AC circuit breaker for the Powerwall+.
  3. Ensure that the Powerwall is turned off by verifying that its Enable switch is set to the OFF position.
  4. Remove both side covers from each Powerwall to be joined.
    Informational PurposesAn informational icon, calling your attention
    Note
    On the Powerwall+, it may be necessary to remove the small plastic insert at the bottom of the covers to help with removal. For the right (LED) side covers, do not disconnect the switch and LED leads. Turn the cover to one side and rest it against the unit chassis.
  5. Using a T20 Torx bit, remove the wiring compartment cover from the Powerwall+.