Tesla Remote Energy Meter "Failed to Configure Meter"

On the Tesla Remote Energy Meter page, a "Failed to Configure Meter" error is displayed when attempting to pair the meter via Wi-Fi.

  1. Confirm the meter is powered on (the LED is ON and blinking green)
  2. Confirm the TRM_XXXXXX network is broadcasting and visible (in range) when standing at the Powerwall 3
    Informational PurposesAn informational icon, calling your attention
    Note
    On the phone, open the list of available Wi-Fi networks to search for the TRM network.
    • If the meter is not broadcasting the TRM_XXXXX network, flip the meter breaker OFF then back ON to reboot the meter, then search for the network again.
      Informational PurposesAn informational icon, calling your attention
      Note
      The meter will only broadcast the TRM_XXXXX network for 10 minutes after it is powered on. If commissioning is performed more than 10 minutes after turning the meter on, reboot the meter so that it will broadcast the network again.
  3. If the issue persists, contact Install Support