Powershare Gateway LEDs
Tesla Asset Controller LEDs
| (1) Power LED | (2) Status LED | Status | Details |
|---|---|---|---|
| Green | Light blue | Ready to commission | Tesla Asset Controller is powered and the config application is running. |
| Green | Green | Not ready to commission | Tesla Asset Controller is powered but the config application is not yet running. If the system remains in this state permanently, contact Install Support |
| Green | Red | Not ready to commission | Tesla Asset Controller is powered but the unit is still booting up. If the system remains in this state permanently, contact Install Support |
| OFF | OFF | No power (12V) to the Tesla Asset Controller | Turn the system ON and wait at least 5 minutes. Unplug the factory-installed low voltage harness from Tesla Asset Controller and confirm power is present. If the system remains in this state, contact Install Support |
Note
During a firmware update, LED 2 may flash red. This is expected behavior, and
the flashing will stop once the firmware update is complete.