2025-02-13

Close Equipment and Turn System On

  1. Before closing any installed hardware, take photos of the completed wiring in the Wall Connector, Powershare Gateway, and main distribution board.
  2. Ensure that all conduit junctions and cable entry points are secure and properly sealed.
  3. Install the Powershare Gateway dead front cover and secure it firmly with the original screw. Mount the Powershare Gateway door, and latch it shut.
    Figure 1. Install the Dead Front Cover and Glass Door
    Informational PurposesAn informational icon, calling your attention
    Note
    During the commissioning process, installers will need to scan a QR code located on the dead front cover.
    Informational PurposesAn informational icon, calling your attention
    Note
    To open the door once it has been installed, simultaneously apply inward pressure on the door while pressing in on the top of the latch (located on the right-hand side of the enclosure) as shown below.
  4. If the system includes solar in the backup circuit, install the following label near the customer's main breaker in their electrical panel:
    Warning IconA warning icon, calling your attention to a possibly risky situation
    CAUTION
    It is critical that this label be installed, and that the customer understands they must turn their solar breaker(s) OFF before attempting to test Powershare functionality by turning the main breaker off. If the main breaker is turned off while solar breaker(s) are still ON, the customer may experience damage to their home loads.
  5. Attach Wall Connector to the wirebox:
    1. Attach the main unit to the wirebox by pushing it inward.
      Warning IconA warning icon, calling your attention to a possibly risky situation
      CAUTION
      Ensure that the wiring is not pinched when attaching the wirebox.
    2. Secure the main unit to the wirebox with the four included fasteners and the included 4 mm hex bit using a bit driver, applying pressure to the faceplate during the process to compress the internal seal. Firmly hand-tighten the four fasteners until they are secure.
      Informational PurposesAn informational icon, calling your attention
      Note
      Do not use a power drill for this step.
  6. Switch on the circuit breaker for the Powershare Gateway and Wall Connector.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    Warning
    Upon powering on the Powershare Gateway and Wall Connector system, allow it to boot up undisturbed for at least one minute. Do not power cycle or reset the Powershare Gateway during this time, as the boot sequence must be completed for the software to operate properly.
    Informational PurposesAn informational icon, calling your attention
    Note
    The door is opened by applying pressure inward and depressing the latch on the right side of the enclosure.